Main / News & Magazines / How To Remove Park Brake Assembly On
How To Remove Park Brake Assembly On
AutoZone Repair Guide for your Brakes Parking Brake Cables. Remove the cable retaining clip at the lever assembly. See Figure 1. Click image to see an. Start by removing the clip from where the cable attaches to the parking brake pull the cable forward, toward you, sliding it out of the tube in the main assembly. Fig. 1: 4WD Pickup parking brake cable assembly — 2WD Pickup similar Remove the parking brake lever adjusting nut from the forward end of the front cable.
Remove the jackstands and lower the vehicle. Remove the forward ball end of the parking brake cable from the control assembly clevis. Remove the cable from . In road vehicles, the parking brake, also called hand brake, emergency brake, or e-brake, (August ) (Learn how and when to remove this template message) seen on the Audi A8) uses a computer-controlled motor attached to each of the two rear brake calipers referred to as the Motor on Caliper (MoC) system. Remove the brake drum and inspect the brake assembly for signs of leakage. Remove the shoes and emergency brake cable clip if required.
В© 2018 a-artfurniture.com